Installation, Connection And - Siemens SIRIUS 3RW44 System Manual

PROFIBUS DP Communication Module
Prerequisites for commissioning
8-18
Required actions
1. The soft starter is installed
2. The PROFIBUS DP communication module is
installed
3. The station address is set on the soft starter
4. The soft starter has been configured (configured
and parameterized)
5. The supply voltage of the DP master is switched
on
6. The DP master is switched to the operating
state RUN
Table 8-2: Prerequisites for commissioning
For further information, refer to ...
Chapter 3 "Installation, Connection
and Branch Layout"
Chapter 8.3 "Installation of the
PROFIBUS DP Communication
Module" on Page 8-7.
Chapter 8.4.3 "Activating the
PROFIBUS DP Communication
Module (Field Bus Interface) and
Setting the Station Address via the
Device Interface using the "Soft
Starter ES Professional" or the "Soft
Starter ES Smart + SP1" Software"
on Page 8-13.
Chapter 8.5 "Soft Starter
Configuration" on Page 8-15
DP master manual
DP master manual
SIRIUS 3RW44 System Manual
GWA 4NEB 535 2195-02 DS 04