Table of Contents
Advertisement
Stick calibration method
*J3-J4 correction is described below. J1-J2 corrections are
performed using the same procedure.
1. Select [CALIBRATION] and access the setup
screen shown below by pushing the RTN
button.
2. Move the cursor to the J3-J4 button and push
the RTN button.
3. Move the J3-J4 stick to the neutral position
and push the RTN button for one second.
4. Set the J3-J4 stick fully to the bottom- right
and wait until the buzzer sounds.
5. Set the J3-J4 stick fully to the top-left and
wait until the buzzer sounds.
6 . T h e a b o v e c o m p l e t e s t h e c o r r e c t i o n
operation. Operate and check if stick
correction was performed normally.
Operation switch setting method
1. Select [SWITCH] and call the setup screen
shown below by pushing the RTN button.
2. Use the edit dial to move the cursor to the
"SA-SH" item corresponding to the switch you
want to change and push the RTN button to
switch to the data input mode.
3. Change the "2Pos" or "3Pos" by turning the
edit dial to the left or right. The display blinks.
It will decide, if the RTN button is pushed. (To
terminate mode change, turn the edit dial or
push the S1 button.)
"3Pos": 3 position switch
"2Pos" : 2 position switch
<Functions of System Menu>
43
Advertisement
Table of Contents
