H/W Setting - FUTABA FMT-03 Instruction Manual

H/W SETTING

H/W reverse
This function reverses the operation signal of the
sticks, switches, trimmer levers, and knobs.
Note: This setting reverses the actual operation
signal, but does not change the display of
the indicators on the display. Use the Normal
mode as long as there is no special reason to
use the Reverse mode.
Stick mode
This function changes the stick mode of
transmitter.
● Select [H/W SETTING] at the system menu and call the
setup screen shown below by pushing the RTN button.
● Select the function name
and return to the System
menu by pushing the RTN
button or pushing the
Home/Exit button.
Operation direction reversal method
1. Select [H/W REVERSE] and call the setup
screen shown below by pushing the RTN
button.
2. Use the edit dial to move the cursor to the
"MODE" item corresponding to the H/W
(hardware) you want to reverse and push
the RTN button to switch to the data input
mode.
3. Change the mode by turning the edit dial to
the left or right. The display blinks. When the
RTN button is pushed, the operation direction
is reversed. (To terminate mode change, turn
the edit dial or push the S1 button.)
"NORM": Normal operation direction
"REV" : Operation direction is reversed.
<Functions of System Menu>
42
Hardware reverse and stick mode, stick calibration, switch position
Note: This will not change the throttle ratchet,
etc. Those are mechanical changes that
must be done by a Futaba service center.
Note: After changing the mode, it is applied
when setting a new model. It is not applied
to an existing model.
Stick calibration
J1-J4 stick correction can be performed.
Note: It does not carry out, when there is no
necessity.
Switch
For set the switch type and position amount
when the stock configuration is changed.
<Edit dial>
S1
Operation direction reversal method
1. Select [STICK MODE] and call the setup
screen shown below by pushing the RTN
button.
2. Use the edit dial to move the cursor to the
"STICK MODE" item and push the RTN button
to switch to the data input mode.
3. Change the mode by turning the edit dial
to the left or right. The display blinks. When
the RTN button is pushed, the stick mode is
changed. (To terminate mode change, turn
the edit dial or push the S1 button.)
(J3)
(J4)
Mode J1
1 Aileron
2 Aileron
3 Rudder
4 Rudder
Scrolling
● Moving cursor
●Access setup screen
(J2)
(J1)
J2 J3 J4
Throttle Elevator Rudder
Elevator Throttle Rudder
Throttle Elevator Aileron
Elevator Throttle Aileron