Table of Contents
Advertisement
MULTIPROP
The system has compatible with the Futaba
MPDX-1 multiprop decoder. One channel can
be expanded to 8 channels by using the MPDX-
1 multiprop decoder. Up to two MPDX-1 can be
used.
*The trim step amount and trim rate are not reset.
● Select [MULTPROP] at the linkage menu and call the
setup screen shown below by pushing the RTN button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
Home/Exit button.
Multiprop selection
1. Select the Linkage Menu multiprop setting
[MULTIPROP] and push the RTN button.
2. The MULTIPROP setup screen is displayed.
3. Select [MP1] and push the RTN button.
4. Scrolling the edit dial and switch the display
to [MP1] or [MP2].
*The display blinks.
[MP1]: Multiprop 1
[MP2]: Multiprop 2
5. Push the RTN button.
Channel setting
1. Select [CH] and push the RTN button.
Scrolling the edit dial and display the
channel to which the MPDX-1 is connected.
*To turn off the multiprop function, set [--] at CH.
2. When the activated channel is selected and
push the RTN button, the multiprop setting
contents are displayed.
Control setting
1. Select the "CONTROL" row of the multiprop
channel whose control you want to set and
push the RTN button.
2. A hardware selection screen is displayed.
Select the hardware which is to set control
and push the RTN button.
CH is extended by MPDX-1 of an option
Servo reverse setting
1. Select the "REVERSE" row of the multiprop
channel which is to be reversed and push
the RTN button.
2. Scrolling the edit dial and switch the display
to [NORM] or [REV].
*The display blinks.
[NORM]: Normal mode
[REV]: Reverse mode
3. Push the RTN button.
End Point Setting
1. Select the "
multiprop channel whose end point is to be
set and switch to the data input mode by
push the RTN button.
2. Adjust the end point by scrolling the edit dial.
Initial value : 100%
Adjustment range : 30-100%
3. After adjustment, push the RTN button.
<Edit dial>
S1
← ↑
" row or "
<Functions of Linkage Menu>
Scrolling
● Moving cursor
● Selecting mode
↓ →
" row of the
67
Advertisement
Table of Contents
