Table of Contents
Advertisement
T1-T6 SETTING
This function adjusts the digital trim's control
step amount and operation mode (T1-T6).
When the flight conditions are set, the trim
operation can be coupled with among all the
conditions which combination mode is selected.
● Select [T1-T6 SETTING] at the linkage menu and call the setup
screen shown below by pushing the RTN button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
Home/Exit button.
Trim position setting (neutral offset)
1. Use the edit dial to move the cursor to the
[POS] item and push the RTN button to switch
to the data input mode.
Set the trim position by turning the edit dial.
Initial value: +0 (neutral position)
(When the RTN button is pushed for 1 second, the control
step amount is reset to the initial value.)
2. Push the RTN button to end adjustment and
return to the cursor move mode.
Control step amount setting
1. Use the edit dial to move the cursor to the
[STEP] item and push the RTN button to switch
to the data input mode.
Set the control step amount by turning the
edit dial.
Initial value: 4
Adjustment range: 0(trim off)-200
(When the RTN button is pushed for 1 second, the control
step amount is reset to the initial value.)
*When the value is made large, the change per step becomes
larger.
2. Push the RTN button to end adjustment and
return to the cursor move mode.
66
<Functions of Linkage Menu>
Digital trim settings
C; combination / S; separate mode selection
1. Use the edit dial to move the cursor to the
[C;COMB./S;SEPA.] item and change to
blinking by turning the edit dial and select
the mode by pushing the RTN button.
[C;COMB]: Combination mode. The trim
data are reflected at all the flight conditions.
[S;SEPA]: Separate mode. Trim adjustment for
each flight condition.
Trim display units
● Percentage(%) display can be selected at
trim.
1. Select "TRIM UNIT" and turn the dial and
switch the display to [%] or [--].
*The display blinks.
[%]: Trim is displayed in % units.
[--]: Trim is displayed numerically as in the
past.
2. When the RTN button pushed, the setting is
changed.
Trim lever T1-T6 isn't
equipped in FMT-03.
<Edit dial>
S1
Scrolling
● Moving cursor
● Selecting mode
Advertisement
Table of Contents
