Link Procedure - FUTABA FMT-03 Instruction Manual

Link procedure (FMT-03 ⇔ FMR-03)
Each transmitter has an individually assigned, unique ID code. In order to start operation, the
receiver must be linked with the ID code of the transmitter with which it is being paired. Once the link
is made, the ID code is stored in the receiver and no further linking is necessary unless the receiver is
to be used with another transmitter. When you purchase additional FMR-03 receivers, this procedure is
necessary; otherwise the receiver will not work.

Link procedure

1. Place the transmitter and the receiver close
to each other within half (0.5m) meter.
Less than 0.5 m
2. Turn on the transmitter.
3. Select [SYSTEM TYPE] at the Linkage menu
and access the setup screen shown below
by pushing the RTN button.
:You can do this through the LINKAGE Menu
and scroll to System and push RTN.
4. When you use two receivers on one model,
you must change from [SINGLE] to [DUAL].
*Only two rec e iv e rs c a n b e us ed . In
"DUAL", two setting items come out. Input,
respectively.
ID of a primary
receiver displays.
In DUAL, a primary receiver
i s l i n k p r e v i o u s l y . N e x t , a
secondary receiver is link.
5. When changing battery fail-safe voltage
f r o m t h e i n i t i a l v a l u e 3 . 8 V , v o l t a g e i s
changed here.
ID of a secondary
receiver displays.
6. [RECEIVER-ID] is chosen by scrolling and the
RTN button is pushed. The transmitter will emit
a chime as it starts the linking process.
7. When the transmitter starts to chime, power
on the receiver. The receiver should link to
the transmitter within about 1 second.
In "Link" Mode
8. If linking fails, an error message is displayed.
Bring the transmitter closer to the receiver
and repeat the procedure above from Step 2.
9. ACT will be chosen if telemetry is used.
It is INH when not using it.
Receiver ON
<Basic Operation> 33