Installation And Removal Of The Battery - FUTABA FMT-03 Instruction Manual

Installation and removal of the FT2F2100BV2
transmitter battery
Battery removal
Note: If you remove the battery while the power
is on, the data you have set will not
be saved.
1. Loosen 2 screws.
2. Open the battery cover.
Screws
3. Disconnect the battery connector.
4. Remove the battery.
5. Close the battery cover completely.
6. Tighten 2 screws.
WARNING
Be careful not to drop the battery.
Never disconnect the battery connector
from the FMT-03 transmitter after turning
off the power until the screen is completely
blank and the transmitter has shut down
completely.
* Internal devices such as memories may be damaged.
* If there is any problem, the message "Backup Error" will
be shown the next time when you turn on the power of
the transmitter. Do not use the transmitter as it is. Contact
supplier.
<Before Use>
22
Battery
Battery cover
Attachment of the battery
1. Remove 2 screws.
2. Open the battery cover.
3. Insert a battery.
4. Connect the battery connector.
5. Close the battery cover completely.
6. Tighten 2 screws.
To Transmitter
Connector
Balance charging connector
: It isn't connected to a transmitter.
*The balance charge connector is not
connected in the state where the battery
is set to a transmitter.
WARNING
When closing the battery cover, be careful
that the battery cover does not pinch the
battery lead wires.
*Shorting of the battery lead wires may lead to fire and
abnormal heating and cause burns or fire disaster.
FT2F2100B V2
Lithium Ferrite
Battery