Error Codes; Clearing Error Codes 06, 08, Or 10; Table 9. Error Codes - Nonin Avant 9600 Operator's Manual

Error Codes

This device includes error codes that indicate error conditions. The following table describes the
error codes for the Avant 9600.
Error Code
Stuck Button (Holding button down more than 30 seconds)
E01
Sound Module Fault
E02
Sound Module Communications
E03
Oximeter Module Communications
E04
Display Module Fault
E05
External Flash Memory Alarm (Memory Non-functional)
E06
ISR Alarm
E08
External Flash Memory Alarm (Patient Data Storage/Retrieval)
E09
External Flash Memory Alarm (Settings Data)
E10
To correct error conditions, perform the following steps or see the "Clearing Error Codes 06, 08,
or 10" section below:
1. Turn the device off and then back on again to remove the error code.
2. If the error continues, disconnect all power (AC and battery), and then reconnect the
power and turn the device back on.
3. If the error is not cleared, note the error code and contact Nonin Technical Service at
(800) 356-8874 (USA and Canada), +1 (763) 553-9968, or +31 (0)13 - 79 99 040
(Europe).

Clearing Error Codes 06, 08, or 10

Error codes 06, 08, and 10 will not clear when the device is turned off and then back on again.
To clear these codes, follow the steps below. Please read through the instructions before
beginning.
1. Press and hold the Plus (+) and Minus (-) buttons at the same time while momentarily
pressing the ON/STANDBY button.
2. Continue holding Plus and Minus until the numerical display shows 888 888. Release
Plus and Minus.
3. Before the revision level (
4. Continue holding Alarm Silence until dnE CLr displays. Release Alarm Silence button.
5. To use the device, turn it off and then on again using the ON/STANDBY button. If error
has not cleared, contact Nonin Technical Service.
20
Table 9: Error Codes
Description
) displays, press and hold the Alarm Silence button.
r
Operating the Avant 9600