Labeling Of The Function Keys - Siemens OP7 Equipment Manual

16.3

Labeling of the Function Keys

Situation
The function keys of the OP7 and OP17 are labeled as follows when deliv-
on delivery ered:
– OP7:
– OP17:
Replacing labeling All the function keys are labeled by means of labeling strips, which are in-
strips
serted in the keyboard from the rear of the OP. For this purpose, the OP has
been provided with an easy-to-use feed-in device. By replacing the labeling
strips, you are in a position to customize the function keys on your OP for a
given system.
Two labeling strips are provided for the OP7 and three for the OP17. Label-
ing strips should be replaced only when the OP has been disassembled. To
replace labeling strips, proceed as follows:
1. Remove from the OP the labeling strips you wish to replace.
2. Insert the new strips from the rear of the OP into the corresponding slits
Figure 16-3 illustrates, by way of an example, how to replace labeling strips
on an OP7.
Figure 16-3 Replacing Labeling Strips (Shown Here for an OP7)
Equipment Manual OP7, OP17
Release 04/99
F1 to F4 and
K1 to K4.
F1 to F8,
K1 to K8 and
K9 to K16.
located on the side of the OP.
16-5