Labeling Function Keys - Siemens simatic hmi op27 Equipment Manual

16.5

Labeling Function Keys

State on delivery
The function keys on the OP27 are labeled ex–works as follows:
S
S
A set of unlabeled strips is enclosed with the OP. This means that the keys on
the OP can be labeled according to individual systems.
Replacing labeling Proceed as follows to replace the labeling strips:
strips
1. Lay down the device with its front plate facing downwards.
2. Remove the labeling strips to be replaced from the unit.
3. Insert the new strips Ê with the inscription facing downwards into the slits
Figure 16-3 Inserting labeling strips
OP27, OP37 Equipment Manual
Release 05/99
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
F1 to F14
K1 to K10
at the rear of the front plate (see Figure 16-3).
Note
Labeling on strips must be smudge-proof before they are inserted. If a key-
board overlay is soiled on the inside, it cannot be cleaned and has to be
returned to the works for replacement.
Ê
OP27 Unit Description
Ê
Ê
16-5