Advanced Display Module (Adm); Operation - Graco 259079 Operation Manuals

Advanced Display Module (ADM) Operation
When main power is turned on by turning the main
power switch (MP) to the ON position, the splash
screen will be displayed until communication and
initialization is complete.
Then the power key icon screen will display until the
ADM power on/off button (A)
first time after system power-up.
To begin using the ADM, the machine must be active.
To verify the machine is active, verify that the System
Status Indicator Light (B) is illuminated green, see
Advanced Display Module (ADM), page 19. If the
System Status Indicator Light is not green, press
the ADM Power On/Off (A) button
Status Indicator Light will illuminate yellow if the
machine is disabled.
3A1705E
Perform the following tasks to fully setup your system.
1. Select pressure for the Pressure Imbalance
2. Enter, enable, or disable recipes. See
3. Set general system settings. See
is pressed for the
4. Set units of measure.
5. Set USB settings.
6. Set target temperatures and pressure. See
. The System
7. Set component A and component B supply
8. Ensure engine is at operating temperature on the
Advanced Display Module (ADM) Operation
Alarm to activate. See System Screen, page 47.
Recipes Screen, page 47.
Advanced Screen 1 — General, page 46.
Advanced Screen 2 — Units, page 46.
Advanced Screen 4 — USB, page 46.
Targets, page 50.
levels. See Maintenance, page 51.
home screen.
See
See
43