Shutting Down The Utx-200L; Reset To Factory Defaults - Roundup UTX-200L Manual

MUFFIN/BAGEL
Selector Buttons (on
both sides of rear of
unit).
Figure 6. Purging Products: Rear of Unit
NOTE: Product is always purged out of the front of
the Toaster using the NEXT button or the MUFFIN/
BAGEL selector buttons. It is NOT possible to
purge product backwards through the unit.

Shutting down the UTX-200L

Follow these steps to shut down the toaster:
1. Turn the Power Switch off.
2. The unit enters cool down mode and displays
OK to Clean. The fans continue to run. This
cool down mode continues for 45 minutes and
shuts the unit down automatically when complete.
IMPORTANT
Do NOT unplug the power cord when the unit is
in cool down mode. Wait for the 45-minute cool
down period to complete before unplugging the
power cord.
WARNING
To avoid possible personal injury and/or dam-
age to the unit, all inspections, tests, and repair
of electrical equipment should be performed by
QUALIFIED SERVICE PERSONNEL. The unit MUST
be shut down and UNPLUGGED before performing
any internal service, except when electrical tests
are required. Use extreme care during electrical
circuit tests. Live circuits will be exposed.
P/N 1010992 Rev. K 03/15
McDonald's
UNIVERSAL TOASTER UTX-200L
OPERATION (continued)

Reset to Factory Defaults

Inadvertent changes to the settings of the UTX-200
could affect how the unit operates. If a fault message
appears, it is recommended that you first attempt to
restore the settings to the factory defaults. This will
restore all settings and parameters to McDonald's
corporate specifications.
NOTE: The UTX-200 should NOT be unplugged
during normal operation or during the 45-minute
cool down period.
Follow these steps to reset the Factory Defaults:
1. Turn the Power Switch off. The red light on the
2. Turn the Power Switch on.
3. Listen for the unit to click three times, then
NOTE: The display will then go blank.
4. Turn the Power Switch off and then back on.
5. Wait for the 20-second countdown to complete.
NOTE: The unit will then display Muffin Wait.
6. Preheat the unit and test for proper operation.
NOTE: If after resetting the Factory Defaults the
unit continues to display a fault/error message, turn
the power off and unplug the power cord. Wait a
few seconds and then plug the power cord back in.
Then repeat steps 2 through 6. If the unit still
displays a fault/error message, immediately call
your Authorized Service Agency for assistance.
13
switch turns off.
immediately press and hold the PREV and
NEXT buttons until the display reads Factory
Defaults Set.