Sirona Control Server / Cbrecoserver; General; Scs Monitor - Sirona Galileos Getting Started Manual

Prerequisites
61 81 155 D 3437
D 3437.202.01.02.02 05.2007

3 Sirona Control Server / CBRecoServer

3
Sirona Control Server
/ CBRecoServer
3.1

General

Sirona Control Server (SCS) and CBRecoServer are services which
run on the Reconstruction Control Unit
SCS is used for:
acquiring scans
managing license information
communicating with the Reconstruction Server (CBRecoServer)
The Reconstruction Server is used for reconstructing 3D volume data.
In order to operate an GALILEOS X-ray unit, SCS and the
Reconstruction Server must be installed on the Reconstruction
Control Unit RCU).
(
i
NOTE
Installation of these components on the RCU is described in the
"GALILEOS Software Installation Instructions".
3.2

SCS Monitor

Sirona Control Server can also be started and stopped using the SCS
Monitor, which only runs on the RCU. This is usually not necessary.
i
NOTE
When the Sirona Control Server is stopped or started, the
Reconstruction Server is also stopped or started.
RCU).
(
9