Input Select; Remote Controller Operation - Eiki EK-350U Owner's Manual

Basic operation

Remote controller operation

Use the remote controller for common operations.
Blank (BLANK)
Press the BLANK button on remote controller
a blank screen displays to replace existing
image. Press the BLANK button or any other
button to restore the image.
Press the BLANK to toggle switch the screen
as shown below:
BLANK → Normal → BLANK → Normal → ......
Image mode selection (IMAGE)
Press the IMAGE button on remote controller
to select required image mode.
Digital Zoom (D.ZOOM+/-)
Press the D.ZOOM+/- button on remote con-
troller to enter the Digital Zoom mode.
Screen size selection (SCREEN)
Press the SCREEN button on remote controller
to select required screen size mode.
Freeze (FREEZE)
Press the FREEZE button on remote controller
to freeze image on the screen and mute the
sound. Press the FREEZE button to cancel the
freeze function.
Volume +/- (VOL +/-)
Increase or decrease volume.
Mute the sound (MUTE)
Press MUTE button on the remote control to
turn off the volume. Press MUTE button again or
VOL+/- button to cancel mute function.
Timer (TIMER)
Press the TIMER button on remote controller.
A timer animation (00:00) displays and starts
timing in format of (00:00-59:59).
Press the TIMER button again to stop timing.
Press the TIMER button again to disable the
timing function.
02 ： 02
Timer display
32
BLANK
IMAGE
VOL
D.ZOOM
+/-
+/-
MUTE
SCREEN
TIMER
Freeze
Blank Image Blank
The Blank screen disappears if no
buttons are pressed in 4 seconds.
Input selection

Input select

Direct operation
Press HDMI 1, HDMI 2, VGA 1, VGA 2, VIDEO,
HDBase T, COMPONENT or USB-A on the
remote control as input source.
Menu operation
1 Press INPUT button on the remote control or
control panel to display the input select menu.
2 Press  button to select VGA 1, VGA
2, HDMI 1, HDMI 2(MHL), HDBaseT,
Component, Video, S-video, Memory Viewer,
Network or USB Display, then press the OK
button.
When input source is from computer
VGA 1
connected to VGA IN 1 terminal with
VGA cable, please select "VGA 1".
When input source is from comput-
VGA 2
er connected to VGA IN 2(YPbPr/
S-VIDEO) terminal with VGA cable,
please select VGA 2.
When input source is from equip-
HDMI 1
ment connected to HDMI 1 terminal
with HDMI cable, please select
"HDMI 1".
When input source is from equip-
HDMI 2(MHL)
ment connected to HDMI 2(MHL)
terminal with HDMI cable, please
select "HDMI 2".
When input source is from equip-
HDBase T
ment connected to HDBaseT termi-
nal with RJ45 cable, please select
"HDBaseT".
Select it when the input source is
Component
from the video equipment connected
to VGA IN 2(YPbPr/S-VIDEO)
terminal via Component to VGA
cable.
Select it when the video input signal
Video
is connected to VIDEO IN terminal.
Note:

- When the "Input search" function is set to "On" in the "Auto setup" function, the input signal will
be searched automatically.
Remote control
HDMI 2
VGA 2
HDBaseT
HDMI 1
VIDEO
VGA 1
USB-A
COMPONENT
INPUT
Control Panel
INPUT
Input select menu
VGA 1
VGA 2
HDMI 1
HDMI 2(MHL)
HDBase T
Component
Video
S-video
Memory Viewer
Network
USB Display
33