Displaying And Maintaining Web Login - HP 3100 v2 Series Configuration Manual

Step
6. Associate the HTTPS
service with an ACL.
7. Set the idle timeout for
Web connections.
8. Create a local user and
enter local user view.
9. Configure a password for
the local user.
10. Specify the command
level of the local user.
11. Specify the Web service
type for the local user.
12. Exit to system view.
13. Create a VLAN interface
and enter its view.
14. Assign an IP address and
subnet mask to the
interface.
For more information about SSL and PKI, see Security Configuration Guide.

Displaying and maintaining Web login

Task
Display information about Web
users.
Display HTTP state information.
Display HTTPS state information.
Command
ip https acl acl-number
web idle-timeout minutes
local-user user-name
•
In non-FIPS mode:
password { cipher |
simple } password
•
In FIPS mode:
password [ hash ] { cipher
| simple } password
authorization-attribute level
level
service-type web
quit
interface vlan-interface
vlan-interface-id
ip address ip-address { mask |
mask-length }
Command
display web users [ | { begin |
exclude | include }
regular-expression ]
display ip http [ | { begin |
exclude | include }
regular-expression ]
display ip https [ | { begin |
exclude | include }
regular-expression ]
52
Remarks
By default, the HTTPS service is not
associated with any ACL.
Associating the HTTPS service with an
ACL enables the device to allow only
clients permitted by the ACL to access
the device.
The default idle timeout is 10 minutes.
By default, no local user is configured.
By default, no password is configured
for the local user.
By default, no command level is
configured for the local user.
By default, no service type is
configured for the local user.
N/A
If the VLAN interface already exists, the
command enters its view.
You could replace this VLAN interface
with any other Layer 3 interface as
appropriate.
By default, no IP address is assigned to
the interface.
Remarks
Available in any view
Available in any view
Available in any view