How to Manage the Device
MDM6000 >> Device Setup >> Mgmt Interface >> IP Address >> Link Redundancy
When link redundancy is activated, the Mgmt interface (bond interface) becomes
active. This Mgmt interface has an IP Address that is used as destination address by
the source.
It is recommended to configure the connected switch/router-ports in portfast mode.
Otherwise a spanning tree protocol event could cause a blocked port towards the
MDM6000.
In a typical Cisco switch configured using rapid spanning tree this is achieved by
setting the ports in portfast mode.
Newtec Proprietary
Confidentiality: Unrestricted
MDM6000 Satellite Modem
V1.0
/
46
314