Table of Contents
Advertisement
Feature Descriptions
To Enable or Disable device redundancy go to the following location:
MDM6000 >> Device >> Redundancy
When device redundancy is enabled, the USS controls the actual operational redundancy state.
By default, device redundancy is disabled.
Initial Redundancy State:
•
Standby (default value): This means when the device starts up and redundancy is enabled, the
initial state of the redundancy is standby. Typically:
– The modulator output is disabled;
– No IP Address on the data interface.
•
Active.
Newtec Proprietary
Confidentiality: Unrestricted
MDM6000 Satellite Modem
V1.0
/
218
314
Advertisement
Table of Contents
