Commissioning The Mover - Truma Mover S User Manual

Loosely route cable through strain relief (k) and secure with
2 sheet metal screws. Depending on the installation situation,
the cable can be led out of the socket holder through one of
the three recesses.
Pin 6
g
Pin 3
B 3,5 x 9,5
Secure safety socket to the (plastic) shaft cover of the cara-
van with 4 bolts, nuts and washers.
M4 x 16
(4 x)
Washer 4,3
(4 x)
No holes must be drilled in the chassis.
Alternatively, the safety socket can be secured using the two
worm drive hose clamps.
Route wire connected to pin 6 (with red stripe) to control unit
(shorten if necessary), crimp on a flat plug and connect as
shown in the connecting diagram.
Route wire connected to pin 3 (black) to control unit (shorten
if necessary), crimp on a ring and screw to negative battery
terminal as shown in connecting diagram.
The connection to the control unit must be made in the
order – nut, battery negative terminal ring, nut, cable
pin 3 ring, nut.
Re-check whether all cables are correctly connected, attached
using the provided clips and cannot chafe.
i
B 3,9 x 33
(3 x)
h
j
Nut M4 (4 x)
Safety socket connection with LED brake lights
This connection must always be used if all brake lights
are of the LED variety! With two conventional brake
lights and a third brake light with LED technology, the connec-
tion is made as described in "Safety socket connection with
conventional brake lights".
7-pin safety socket
Connect pin 3 of the caravan plug to the negative battery
terminal.
Connect pin 3 of the safety socket to the controller (with one
wire of the 2-wire cable).
13-pin safety socket
Connect pin 11 of the caravan plug to the negative battery
k
terminal.
Connect pin 11 of the safety socket to the controller (with one
wire of the 2-wire cable).
If it is not possible to make a connection using pin 11 (pin
missing, for example), use pin 3 as an alternative.
It must be ensured that ground connections pin 11
and pin 3 are not interconnected in an electrically
conductive manner at the trailer side!
Connecting diagram with LED brake lights
Fuse
Engagement Safety
motors contact
– + – +
1
6
Safety
7
socket
5
4
7-pin
1
Caravan 6
7
plug
5
4

Commissioning the Mover

Ensure the battery used to operate the Mover is fully charged.
Park the caravan outside on an open, level surface and apply
the handbrake. Ensure that the rollers are disengaged from
the road tyres and the corner steadies are raised.
Connect battery terminals to battery, check that all cables are
secure and not hot or indicating signs of short circuits, etc.
Plug the 13-pin plug into the safety socket.
If there is a fault in both caravan brake lights, the power
circuit of the safety socket is not closed. In this case the
Mover cannot be operated.
Move slide switch on remote hand set to the "On" I position.
This switches the remote hand set on – green LED flashes for
5 seconds in combination with the acoustic alarm until the
control unit is ready for operation. If LED does not illuminate,
check polarity and condition of batteries in remote hand set.
Drive
motor
Battery
– +
4 3
8
7 9
2
1
6 10
4 2
3
11
5 3
13 12
13-pin
8
7 9
2
1
6
10
4 2
3
3 11
5
13 12
Drive-
motor
2 1 1
-
+
21