Subscribe to Our Youtube Channel
Related Manuals for Truma Mover smart A
Summary of Contents for Truma Mover smart A
- Page 1 Mover smart A Mover smart M Operating instructions Page To be kept in the vehicle...
-
Page 2: Table Of Contents
1800 kg and the Mover smart A for single-axle caravans with an overall – Do not place the remote control which is ready for weight of up to 2000 kg. -
Page 3: General Information
Approval Battery type Battery capacity The Truma Mover is type-tested and has been awarded a type approval (ABE) for Germany. Approval from an automotive expert is not required (exception when installing the low chassis kit). The ABE must be in the vehicle. -
Page 4: Operating Instructions
Engaging Mover smart M Move the caravan forward – Insert the engagement key onto the toggle crank. Engage the Mover (only Mover smart A) Rotate the caravan clockwise (via right axle) Switch off (red) / emergency off switch Rotate the caravan anti-clockwise (via right axle) -
Page 5: Switching On The Remote Control
– Move the caravan in the desired direction using the direction arrows (Figure 2 - 3/5/6/7/9). The Mover smart A can also be manually disengaged if there is no power available or a malfunction prevents If the opposite direction arrows (Figure 2 - 5/9 or 3/7) are automatic disengagement. -
Page 6: Switching Off The Remote Control (Emergency Off)
You or your caravan dealer can easily check or maintain The LED lighting goes out. your Mover every year during the annual inspection of your caravan. If you have any doubts, please contact Truma Service (www.truma.com). Interrupting the power supply Following each use of the Mover, disconnect the Mover power supply at the battery cut-off switch and remove the key. -
Page 7: Inspections
Mover’s battery connector cable may be replaced only by an – Following the annual inspection, check whether all motors original Truma spare part (part no. respond properly to the commands of the remote control. 60040-00169) – At least every two years, the Mover must be inspected –... -
Page 8: Tuning The Electronic Control Unit To The Radio Remote Control
Type: Manoeuvring system – Is the remote control aligned with the control unit? Perform Version: Mover smart M, Mover smart A the steps under “Tuning the electronic control unit to the Manufacturer radio remote control” on page 8. Truma Gerätetechnik GmbH & Co. KG –... -
Page 9: Manufacturer's Warranty Declaration (European Union)
1. Scope of the manufacturer’s warranty networked control of the appliance, if the control units and software have not been approved by Truma or if the As the Manufacturer of the appliance, Truma undertakes Truma control unit (e.g. Truma CP plus, Truma iNetBox) a warranty towards the consumer that covers any material... - Page 10 Should problems occur, please contact the Truma Service Centre or one of our authorised service partners (see www.truma. com). In order to avoid delays, please have the unit model and serial number ready (see type plate). Truma Gerätetechnik GmbH & Co. KG Service Wernher-von-Braun-Straße 12...
Need help?
Do you have a question about the Mover smart A and is the answer not in the manual?
Questions and answers