Special Accessory Installation; Installation Of The Drive Units; Choice Of Location - Truma Mover S User Manual

Special accessory installation

1. Set of screws
for height compensation with
spacer plates, max. 45 mm,
eight DIN 933 screws
M10 x 95 8.8, galvanized,
part no. 60010-70000.
2. Spacer plate kit
(two 15 mm spacer plates)
for height compensation
max. 45 mm (3 plates) at each
side (e.g. installed behind axle)
part no. 60010-66000.
3. Low chassis kit
for height compensation for
caravan / trailer with frame height
of less than 140 mm,
part no. 60010-64900.
In Germany, this installa-
tion kit must be accepted
by a vehicle expert.
4. AL-KO Vario III / AV
Installation kit
for caravans with
AL-KO Vario III / AV Chassis
(frame thickness less than 2.8 mm)
mandatory,
part no. 60010-21500.
5. Mover mounting set
for Eriba Touring
part no. 60030-09000.
Installation is not possible in some cases because of
attachments to the underbody. Contact your dealer if
necessary.
Detailed installation instructions are provided with the
relevant mounting set.
The Mover SE R / TE R is not approved for installa-
tion on caravans / trailers with any other chassis!
Any drilling (exception: when using low chassis kit) or welding
to the chassis is not allowed. Under no circumstances remove
any suspension components from the chassis.

Choice of location

The Mover should preferably be installed in front of the axle,
but can also be installed behind the axle under special circum-
stances (e.g. lack of space). Only the bolts that are provided
must be used to secure the Mover (or the add-on parts
provided as special accessories).
18

Installation of the drive units

The frame of the vehicle must be kept free of rust and heavy
soiling and without any damages to the suspension
components.
The wheels and tyres that are fitted to the caravan must be of
the same size and model and inflated as per the manufacturer's
instructions.
Remove all components from packing and place on the floor.
In order to maintain the validity of the General Operating
Permit (ABE) the provided factory plates (f) must be at-
tached on the left and right sides of the cross strut between
the drive unit retaining plates.
Loosely attach the drive units to the lateral bar. The bolts
(lock nuts) must be no more than finger-tight.
Nut M8 (4 x)
Place the mounting set (b) on the vehicle frame and secure
using the two bolts (c), tight enough so that it can just about
be moved on the frame.
c
Washer 8
(8 x)
Self-locking nut M8 (4 x)
f
M8 x 30 (4 x)
M8 x 60 (4 x)
b