Truma Mover XT Operating Instructions Manual
Hide thumbs
Also See for Mover XT:
- Operating and installation instructions (100 pages) ,
- Operating instructions manual (10 pages) ,
- Information (4 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Truma Mover XT
Summary of Contents for Truma Mover XT
- Page 1 Mover XT / XT2 Operating instructions Page To be kept in the vehicle...
-
Page 2: Table Of Contents
Battery care (including maintenance-free batteries) .... 3 hazards. Function description ............ 3 Intended use ................ 4 – The Mover XT / XT2 may be operated only by persons of Approval ................ 4 legal age who have been made aware of the potential risks Operating instructions ............ 4 when using the product and who are able to safely operate Remote control .............. 4... -
Page 3: General Instructions
Charger rollers and the tyres (see “Fitting the drive units”). – When jacking up the vehicle, do not use the Mover XT / XT2 For optimum battery charging we recommend the Truma as a support point as this could damage the drive unit and BC 10 charger, which is suitable for all battery types up to the vehicle. -
Page 4: Intended Use
Any modifications made to the device, or the use of any spare parts or functionally significant accessories other than original The following options are available for controlling the caravan: Truma parts, or failure to comply with the contents of the op- using the control knob only using the slide control only erating and installation instructions invalidates the warranty and precludes any liability claims. -
Page 5: Remote Control Led Flashing Code And Acoustic Signal
Only Mover XT2 control knob The remote control can be switched on again only if it It is not possible to turn a caravan with a two-axle chassis on has been switched off for at least 2 seconds. If the re- the spot. -
Page 6: Disposal
The position indicator shows how far the Mover XT / X2 is engaged: 1-2: incompletely engaged 3: completely engaged No number visible: Engagement position Figure 2 Flat, used batteries can leak and damage the remote control. Remove the batteries if the remote control is not Mover being used for a long period of time. -
Page 7: Coupling To A Towing Vehicle
/ or injury due to sliding drive rollers. After disengaging the Mover XT / XT2, switch it off on the re- mote control and then unplug the 13-pole plug / adapter from – At least every 2 years have an expert check that there is the safety socket and plug it into the 13-pole supply socket of no rust on the Mover XT / XT2, that the attachments are... -
Page 8: Pairing The Electronic Control Unit With The Radio Remote Control
Operating voltage If these actions do not remedy the problem, please contact 12 V DC Truma Service. Power consumption on average approx. 28 A up to a maximum of 150 A Quiescent current consumption Pairing the electronic control unit with the <... -
Page 9: Manufacturer's Warranty
Truma or if the Truma control unit (e.g. Truma CP plus or Truma iNetBox) has not been exclusively used for controlling... - Page 11 Should problems occur, please contact the Truma Service Centre or one of our authorised service partners (see www.truma.com). In order to avoid delays, please have the unit model and serial number ready (see type plate). Truma Gerätetechnik GmbH & Co. KG Service Wernher-von-Braun-Straße 12...