Keysight N5221A Service Manual page 25

PNA Series Microwave Network Analyzers
N5221A/22A
Required Service Test Equipment (Cont'd)
a
Equipment
T-8 TORX driver
T-10 TORX driver
T-15 TORX driver
T-20 TORX driver
1/4 inch and 5/16 inch open-end
wrench
5/16 inch, open-end torque wrench
(metric equivalent is 8 mm)
1 inch, open-end torque wrench
(metric equivalent is 26 mm)
9-mm, socket or open-end wrench
20 mm, open-end torque wrench
Adjustable antistatic wrist strap
Antistatic wrist strap grounding
cord (5 foot)
Static control table mat and earth
ground wire
USB flash ROM drive
a. Unless specified otherwise, equipment listed is required for all analyzer models.
b. P = Performance tests, A = Adjustments, T = Troubleshooting, R = Repair, V = System verification
Service Guide N5222-90001
Critical Specifications
Tools
0.6 N-m (5 in-lb) setting
0.5, 0.8, and 1.0 N-m
(4, 7, and 9 in-lb) settings
1.5 N-m (14 in-lb) setting
2.4 N-m (21 in-lb) setting
Thin profile
1.1 and 2.4 N-m (10 and 21
in-lb) settings (for semi-rigid
cables)
8.1 N-m (72 in-lb) setting (for
Port 1 and Port 2 connector
nuts)
2.38 N-m (21 in-lb) setting (for
all front panel and most rear
panel connector hex nuts)
0.9 N-m (8 in-lb) setting (for
measurement port
connections)
Static Safety Parts
N/A
N/A
N/A
Miscellaneous
N/A
General Product Information
Required Service Test Equipment
Recommended Alternate
Model or Part Model
Number Number
N/A N/A
N/A N/A
N/A N/A
N/A N/A
8710-0510 N/A
N/A
N/A
N/A N/A
N/A N/A
N/A
8710-1764
9300-1367 None
9300-0980 None
9300-0797 None
Any None
b
Use
R
T, R
T, R
T, R
A, R
T, R
R
R
P, A, T
P, A, T
P, A, T
P, A, T
P, A, R
2-7