Hearth and Home Technologies PVLP-SLP Installation Instructions Manual page 26

WARNING!
• Power Vent must be paired to IFT-ACM before
installation is complete.
• If you have 120 VAC Power & Gas to applance:
- Immediately after connecting the PVI-WH
connector to the IFT-ACM, the IFT control
must be paired to recognize the Power Vent
as part of the control configuration.
- Appliance and Power Vent function must be
verified before installation is complete.
- Consult installation manuals for details.
• If you DO NOT have 120 VAC Power & Gas:
- DO NOT connect PVI-WH connector to IFT-
ACM.
- Disconnect 6V power to lock-out appliance.
Failure to follow instructions could result in a fire or explosion.
Figure 4.10. IFT-RC400 Wiring Diagram with Power Vent
11. Attach jumper wire included in manual bag of Power
Vent between black wire on 6 pin harness and red wire
on accessory cable. See Figure 4.10.
12. Attach brown wire from 6 pin harness to brown wire on
accessory cable. See Figure 4.10.
13. Plug (3) connector plug on accessory cable into Pow-
er Vent port on IFT-ACM. See Figure 4.10.
26
Hearth & Home Technologies • Power Vent Low Profile (PVLP-SLP) Instructions • 4052-900 Rev. M• 09/17
FLAME
SENSE IGNITER
IFT-RC400
REMOTE
CONTROL
S
RF MODULE
STEP 12
(OPTIONAL ON SOME
ADAPTER
MODELS ONLY)
WIRE ASSEMBLY
I
STEP 14
GRN/WHT/BLK
LED
6 PIN
CONTROL
BLK
BRN
RED/
RED/
BLK
BLK
(OPTIONAL)
STEP 13
ACCESSORY CABLE
BRN
BRN
BLK RED
JUMPER WIRE
STEP 11
RED
14. Plug harness from IFT-ACM to junction box. This will
already be plugged in if equipped on appliance, or it
is included in the IFT-ACM kit if the appliance is not
equipped with an IFT-ACM
15. Restore Power to the control module.
MODULE
RESET
SWITCH
TO JUNCTION
BOX 110-120
VAC
FAN 110-120 VAC
(OPTIONAL)
PVLP
POWER VENT