Reset Average Salt & Adjust Chlorinator Output - Hayward ProLogic Troubleshooting Manual

How To: Reset Average Salt
Follow these steps ONLY if Salt Chlorination is Enabled. The Average Salt level needs to
be reset after initial start up, after a board replacement, following major pool
chemistry adjustments, and when a cell is replaced.
Step 1
Step 2
The active salt readings (instant salt) appears in the 'Diagnostic If all zeros or if 'Chlorinator Off Percentage Met', press (+) key.
Menu'. Press the 'Menu' button repeatedly, until the 'Diagnostic IF, after a short countdown delay, the display does not revert to
Menu' appears. Then press (>) one time. zeros, refer to step 3.
Step 3 Step 4
Press the (+) key to replace the existing average with this new
Above is an example of the updated instant salt reading in PPM.
If this instant salt reading varies from the average press the (>) instant salt reading; this will start the average process over
again. Press the 'Menu' button to exit.
one time, then go to step 4.
NOTE: The main circulation pump MUST be ON and the chlorinator AND flow switch MUST have flow to
successfully complete this process.
6