Wireless Remote Not Pairing To Prologic - Hayward ProLogic Troubleshooting Manual

7. Wireless Remotes Not Pairing to ProLogic
All Wireless remotes that pair with the ProLogic run of RF. There are up to 5 RF
channels that can be used to counteract possible interference.
Check for antenna
Step 7A
Verify that a RF antenna is attached or connected to the
ProLogic system. NOTE: the antenna may extended
away from the main panel. IF an antenna is visible
please go to step 7B. IF not, please contact tech support
for more assistance: (908) 355-7995.
29
Service mode
Step 7B
When the system is in service mode, all remotes are
temporarily disabled. Verify the system's red 'Service'
LED is NOT illuminated. IF illuminated, press the red
service button until the LED goes out. IF not on,
proceed to step 7C.