Incubation - Rcom Reptile MAX 60 User Manual

Preparation for Incubation / How to Start Incubation
Please perform incubation "test run" to check all functions before incubating with real eggs.
▶ Open power cap to plug-in and close power
cap again to lock bolt.
When locking bolt, be careful for cord
not to be trapped in the power cap.
Open power cap to find the sticker
indicating a rated voltage on the ⓐ
that was attached to the main body.
It is necessary to plug-in after checking
if power supply voltage to use is proper.
▶ In case of connecting power cord of incubator, incubation starts at the existing set temperature and humidity.
[temperature of initial shipment 26.1℃ (78.98℉)]
There can be some odor the first time you use incubator, which is normal.
▶ The first time you connect power, FND light will blink and
pump will work for about 2sec. Then, incubator version
will be indicated on FND for about 1 sec.
▶ After version indication, buzzer sounds for about 15sec.
At the same time, present temp. & humiditydisplayed and
power failure alarm indication ⓐ is blinking.
▶ Press button to remove buzzer and alarm indication. (Buzzer will be removed automatically after 15sec.)
※ Notice of Power Failure : If power is turned off and then
on again because of power failure or by mistake, first dot
will blink.
Quick Start : If you just connect power,
it automatically starts incubation with factory setting.
[Factory setting : Temperature 26.1℃ (78.98℉)]
▶ It indicates present temperature and humidity of incubator, and it goes up to the set temperature value in 1~2
hours. (No humidity control function)
※ The artificial intelligence system memorizes and classifies ambient conditions for keeping optimum temperature,
and temperature can move up slowly at the first stage.
DIGITAL INCUBATOR

3. Incubation

3. 부화
ⓐ
(1) Preparation for Incubation /
How to Start Incubation
Power
Cord
Power Cord
9