Rcom Reptile MAX 60 User Manual page 8

2. Before Use
▶ Incubation humidity depends on the quantity of the water mixed with reptile vermi, surrounding temperature and
humidity, and incubator set temperature. Please check the moisture state of reptile vermin every two weeks.
In case that the reptile vermi was completed dried, it may be in very dry state by absorbing the surrounding
humidity of incubator inside and egg. It is good to start after understanding the required environment for
each reptile kind and making previous test if incubation environment is proper to minimize incubation failure.
It is not good for the vermiculite to be reused after an incubation term incubation. The incubation rate will
fall because of bacterial contamination. [It might be possible to purchase the vermiculite at the place you
purchased the incubator.]
After the egg deposition, it is recommended
to lay the eggs in the incubator without
delay. Moreover we commend to mark
the top side of the eggs to make sure
the topside will always be up during t
he incubation process.
▶ Fill the tray with vermi, and bury the half
of eggs.
▶ Insert container tray carefully in the bottom
body.
▶ Put sensor line into container tray furrow and
be sure to close all covers of tray and sight glass.
In case that the sight glass isn't closed
completely, temperature doesn't go up.
Be careful.
8
(2) How to Assemble
Marking
CAP
DIGITAL INCUBATOR