Function Settings - Rcom Reptile MAX 60 User Manual

4. Function Settings

Abnormal high temp. alarm setting method
Abnormal high temperature alarm function?
It is a function informing users of that the temperature of incubator inside raised because of abnormal
temperature, and in case that the surrounding temperature of incubation room is higher than the set
temperature of incubator, it is continuously alternated ringing buzzer and displaying set temperature range
(example: 3℃) on the temperature window. After that, even though temperature is recovered to the normal
state, it keeps ringing buzzer and flickering repeatedly until it is cancelled by pressing OK button.
▶ In case of pressing
set method stage, "HI" is displayed at the temperature
window for 0.5 seconds and the alarm set value flickers.
▶ When the alarm set value flickers, press
button each to increase or decrease its set value to 1℃
level. [Default setting : OFF = 0℃ (0℉)]
▶ In case of pressing
value, alarm set value is saved and "LO" is displayed
(abnormal low temperature alarm) as a next step at
temperature display window for 0.5 seconds and its set
value flickers.
EX :
Abnormal low temp. alarm setting method
▶ In case of pressing
high temperature set method stage, "LO" is displayed at
the temperature window for 0.5 seconds and the alarm
set value flickers.
▶ When the alarm set value flickers, press
button each to increase or decrease its set value to 1℃
level. [Default setting : OFF = 0℃ (0℉)]
▶ In case of pressing
value, alarm set value is saved and "HI" is displayed
(abnormal high humidity alarm) as a next step at humidity
display window for 0.5 seconds and its set value flickers.
In case of abnormal low temperature: In case of abnormal low temperature, "LO" is displayed at humidity
display window and it is the same as at the abnormal high temperature.
EX :
12
(3) Abnormal high, Low temp.
alarm setting method
button one time at the temperature
or
button after changing into wanted
※ It displays that it was 3℃ (5.4℉) higher than incubation set
value during incubation.
button one time at the abnormal
or
button after changing into wanted
※ It displays that it was 2℃ (3.6℉) lower than incubation set
value during incubation.
Step 3
Step 4
Step 5
Step 6
DIGITAL INCUBATOR