Rcom Reptile MAX 60 User Manual page 13

REPTILE MAX 60 Incubator doesn't have any automatic humidity control function. But, it has an alarm function
informing it to the users in case of getting out of necessary humidity range during incubation. In case that alarm
set humidity range is too sensitive, frequent alarm may ring, however, in case of cancelling this function, just OFF
alarm function. (See step 7~10) ※ Abnormal humidity alarm rings for 15 seconds only in the initial occurrence.
Abnormal high humi. alarm setting method
Abnormal high humidity alarm function?
It is a function informing users of that the humidity of incubator inside raised because of abnormal humidity,
and in case that it is higher than the set humidity of incubator, it is continuously alternated ringing buzzer and
displaying set humidity range(example: 5%) on the humidity window. After that, even though temperature is
recovered to the normal state, it keeps ringing buzzer and flickering repeatedly until it is cancelled by pressing
OK button.
▶ In case of pressing
low temperature set method stage, "HI" is displayed at the
humidity window for 0.5 seconds and the alarm set value
flickers.
▶ When the alarm set value flickers, press
button each to increase or decrease its set value to 1%
level. [Default setting : RH 95%]
▶ In case of pressing
value, alarm set value is saved and "LO" is displayed
(abnormal low humidity alarm) as a next step at humidity
display window for 0.5 seconds and its set value flickers.
EX :
Abnormal low humi. alarm setting method
▶ In case of pressing
high humidity set method stage, "LO" is displayed at the
humidity window for 0.5 seconds and the alarm set value
flickers.
▶ When the alarm set value flickers, press
button each to increase or decrease its set value to 1%
level. [Default setting : RH 70%]
▶ In case of pressing
value, alarm set value is saved and "dtg" is displayed
(daily temperature range) as a next step at humidity display
window for 0.5 seconds and its set value flickers.
In case of abnormal low humidity: In case of abnormal low humidity, "LO" is displayed at temperature display
window and it is the same as at the abnormal high humidity.
EX :
DIGITAL INCUBATOR
4. Function Settings
button one time at the abnormal
or
button after changing into wanted
※ It displays that its inside humidity was temporarily higher than abnormal
high humidity alarm set value(RH 95%) during incubation.
button one time at the abnormal
or
button after changing into wanted
※ It displays that its inside humidity was temporarily lower than abnormal
low humidity alarm set value(RH 70%) during incubation.
(4) Abnormal high, Low humi.
alarm setting method
Step 7
Step 8
Step 9
Step 10
13