What is an Incubation Room?
Incubation room? It means the place where the incubator is installed and operated, and as it has much effect on
incubation rate according to the environment of incubation room, it is good to install incubator at the place where
there is little noise and vibration in the vicinity and the temperature range isn't severe in the temperature of 22~25
(71.6~77
℉
). In particular, as there are many cases that the temperature falls rapidly in the nighttime differently
from the daytime, it is necessary to check certainly, and during daytime, incubator must not be exposed directly to
the sunlight.
How to Assemble
When installing reptile incubator, in case that the temperature of incubation room is higher than its set
temperature, the temperature control of incubator inside may not be done normally. The set temperature
of incubation room should be around 4
▶ Unpack incubator and separate each part to do assembly
and check if there is some omission or damage
(Don't throw away product box to utilize it for safe product
keeping.)
REPTILE MAX 60 Incubator doesn't have any automatic
humidity control function. It is recommendable to incubate
by testing if its required humidity is kept after mixing reptile
vermi and water into container tray rather than incubating
immediately and raising temperature up to the incubating
temperature.
▶ Adding water to vermiculite, inner incubator humidity shall
be increased by 15~20%. Even if the humidity which is
shown on the display window is higher or lower (15-20%)
compare to best incubation condition, that does not really
effect on hatching rate. If hatching is failed, check the
condition of eggs.
▶ Mix water 700~800cc with a bag of reptile vermi per one container tray and pour into 40~45mm height.
It is possible to purchase the vermiculite for reptile
incubation separately.
DIGITAL INCUBATOR
2. Before Use
℃
(7.2
℉
) lower than incubator set temperature.
40~45mm
(1) What is an incubation Room?
(2) How to Assemble
℃
700~800cc
7
Need help?
Do you have a question about the Reptile MAX 60 and is the answer not in the manual?
Questions and answers