Before Use - Rcom MARU DELUXE Hatcher & Brooder MX-100HBD User Manual

What is an Incubation Room?
The Incubation Room is a confined space for setting and operating an MARU H&B efficiently.
An Incubation Room environment has a considerable effect on hatch rate. Controlling the MARU H&B
environment is recommended; there should be little noise or vibration and constant temperature ranging
upwards from 28℃(82.4℉) with small variation in temperature. For optimum performance, pay attention
that your MARU H&B isn't exposed to temperature drops compared with daytime. Do not directly exposed the
MARU H&B to sunlight during daytime. also, please MARU H&B where direct wind from air-conditioner not to reach.
If you set a high temperature, condensation will occur and may causes water to leak from the machine and
it which is not a technical problem. You need to keep temperature between 28
How to Install the this MARU H&B
▶ Please set the machine horizontally on a stable, tallish
table (50[cm] or above)
▶ Ensure the machine is completely level, so the door can
close completely.
▶ Connect silicon tubing onto the nipple of machine, and
the other end of silicon tubing into a water container.
Do not place water container on top
of the machine. It may flood the
humidity nit.
Using tap water or underground water
instead of distilled water in this unit's
humidification device will cause serious
debris (scale) to develop. In this case,
the inconvenience of frequent cleaning
will occur and when left alone, may
become the cause of malfunction or
breakage. If you have any questions
regarding such problems,
please contact the place of purchase
and failure of the device due to the
consumer negligence(due to non-cleaning), even if it occurred with in the free A/S period, repair
charges might occur when repairing, so use of distilled water is highly recommended.
▶ To set up the Air Filter, please open the Door, and look at the ceiling inside of the machine. You can set up the
Air-filter as shown in the picture below.
Clean the air filter every 2 weeks .
[Refer to the Page 17]
DIGITAL INCUBATOR

2. Before use

WATER IN
*MX-380HBD
(1) What is an Incubation Room?
(2) How to install this MARU H&B
(82.4 ).
℃ ℉
50cm
*MX-100HBD
7