Before Use; What Is An Incubation Room - Rcom REPTILE PRO 90 User Manual

North America Sales & Service www.RcomCo.com

2. Before Use

What is an Incubation Room?

Incubation room? It means the place where the incubator is installed and operated, and as it has much effect on
incubation rate according to the environment of incubation room, it is good to install incubator at the place where
there is little noise and vibration in the vicinity and the temperature range isn't severe in the temperature of 22~25
(71.6~77 ). In particular, as there are many cases that the temperature falls rapidly in the nighttime differently
℉
from the daytime, it is necessary to check certainly, and during daytime, incubator must not be exposed directly to
the sunlight.
How to Assemble
When installing reptile incubator, in case that the temperature of incubation room is higher than its set
temperature, the temperature control of incubator inside may not be done normally. The set temperature
of incubation room should be around 4
4
3
2
1
8
Rcom Reptile Incubator Pro 90 User Manual
(1) What is an incubation Room?
(2) How to Assemble
℃ (7.2 ℉ ) lower than incubator set temperature.
View Window
Tray
Fit the water cap. Fit the water cap.
* *
Water Cap
Main Body-1
Main Body-2
5
▶ Lock the three locking buttons at the front
and rear of the incubator.
6
Serial NO.
▶ Insert the power cord in the socket at the
back of the main body.
▶ Register Serial NO. in the back of main body
(up). Free warranty period is extended to 2
years.(See 22 page)
DIGITAL INCUBATOR
℃