Heinner HEM-150BK Instruction Manual page 6

www.heinner.com 800W, 50Hz, 230V
5. Place the carafe on the removable shelf.
6. Plug the power cord into the outlet. Turn the steam knob to position, and the
indicator is illuminated, wait for about 2 minutes, there will be coffee flowing out.
7. After desired coffee has obtained, you should turn steam knob to PAUSE position, the
indicator go out and the coffee maker stops working. If you want to make coffee again, only
turn the steam knob to position.
WARNING: Do not leave the coffee maker unattended during making the coffee!
8. Before removing steel mesh or opening the tank cover, make sure the pressure in the tank
shall be released. The method is turn the steam knob to the OFF/RELEASE position firstly, the
steam in the tank will eject from the frothing device. After pressure has released, and wait for
the steel mesh cooling down, you can remove the steel mesh or open the tank cover.
Note: the metal funnel gets hot during operation. If the machine has been in operation, do
not touch the metal parts when removing the metal funnel. After removing, cool the metal
parts under running water.
9. After finishing making the coffee, you can take the metal funnel out through turn
clockwise, and then pour the coffee residue out with the steel mesh pressed by press bar. Let
them cool down completely, then rinse under running water. (When assemble the steel mesh
again, you shall turn over the press bar to the original position).
 FROTHING MILK/ MAKE CAPPUCCINO
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Method:
1. Prepare espresso first with container big enough according to the part "B. MAKE ESPRESSO
COFFEE".
2. Fill a jug with desired amount of milk for each cappuccino to be prepared, you are
recommended to use whole milk at refrigerator temperature (not hot!).
Note: In choosing the size of jug, it is recommend the diameter is not less than 70±5mm, and
bear in mind that the milk increases in volume, make sure the height of jug is enough.
3. Turn the steam knob to the position, the indicator will light up.
4. Insert the frothing device into the milk about two centimetres, after about 2 minutes, the
steam will come out from the frothing device. Froth milk in the way moving vessel round
from up to down.
5. When the required purpose is reached, you can turn the steam control knob to PAUSE
position stop frothing. After finishing, remove the jug and turn the steam knob to
OFF/RELEASE position release the residual steam in the tank.
5