Changing Parameters - Samson TROVIS 5579 Mounting And Operating Instructions

Start-up
q
Deactivate the function block.
Display shows: F__ - 0
Confirm settings.
If the function block is not closed, further function block parameters can be adjusted.
Proceed as follows:
Make the required changes and confirm.
If applicable, the next function block parameter is displayed.
Confirm all parameters to exit the opened function block.
To adjust additional function blocks, repeat the steps in the fields highlighted in gray.
q
Select End .
Exit configuration level.
q
Select End .
Return to operating level.
2.3

Changing parameters

Depending on the set system code number and the activated functions, not all parameters
listed in the parameter list in the Appendix (–> section 12.2) might be available.
The parameters are grouped by topics:
4
PA1: Heating circuit Rk1 (
4
PA2: Heating circuit Rk2 (
4
PA3: Heating circuit Rk3 (
4
PA4: DHW heating
4
PA5: System-wide parameters
4
PA6: Communication parameters
4
PA7: Not used
4
PA8: Not used
24
EB 5579 EN
)
)
)