Setting Vacation Periods - Samson TROVIS 5579 Mounting And Operating Instructions

Operation

1.8.2 Setting vacation periods

During vacation periods, the controller constantly remains in reduced operation. A maximum
of 10 vacation periods can be entered. Each vacation period can be separately assigned to
the heating circuits Rk1 to Rk3 and/or the DHW circuit.
Parameter
Vacation period (START, STOP)
Proceed as follows:
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
To enter additional vacation periods, re-select – – – – and repeat the steps in the fields
highlighted in gray.
18
EB 5579 EN
WE Level / Range of values
– Extended operating level / 01.01 to 31.12
q
In extended operating level, select vacation periods.
Display shows:
Open data point for vacation periods.
Display shows: START , – –.– – (day.month)
q
If applicable, select – – – – .
Activate editing mode for start date of vacation period.
blinks.
q
Edit start date of vacation period.
Confirm start date of the vacation period.
Display shows: STOP, – –.– – (day.month)
q
Edit end of vacation period.
Confirm end of vacation period.
Black squares under 1 to 4 at the top of the display
indicate the assignment of the vacation periods to the
individual control circuits.
q
Select the control circuit to which the current vacation
period should apply.
Current vacation period applies to circuit Rk1
Current vacation period applies to circuit Rk2
Current vacation period applies to circuit Rk3
Current vacation period applies to DHW circuit
The vacation period can be assigned to a single control
circuit or any combination of all four circuits (Rk1 to
Rk3, DHW circuit).