8-Bit Switches - GE N60 Instruction Manual

5.7 CONTROL ELEMENTS

PATH: SETTINGS CONTROL ELEMENTS
 8-BIT
 SWITCH 1
5
This feature allows switching between two input arguments defined by 8 bits each. The bits are specified by FlexLogic™
operands. The feature could be viewed as an integrated two-position switch for 8 logic signals.
Typically this element is applied in conjunction with the Digitizer and 8-bit Comparator features.
The switch runs every half power cycle (every four protection passes).
• 8BIT SW 1 ARG A0 to 8BIT SW 1 ARG A7: These settings specify FlexLogic™ operands that constitute the first (A)
input of the switch. These operands are routed to the output operands if the control input is in the "Off" position.
• BIT SW 1 ARG B0 to 8BIT SW 1 ARG B7: These settings specify FlexLogic™ operands that constitute the second (B)
input of the switch. These operands are routed to the output operands if the control input is in the "On" position.
• 8BIT SW 1 CONTROL: This setting specifies FlexLogic™ operands to control the routing between the A and B inputs
of the switch. If the control operand is in the "Off" state, the first (A) input is switched to the output. If the control oper-
and is in the "On" state, the second (B) input is switched to the output. The switching takes place instantaneously.
5-178


8-BIT SWITCHES

8BIT SWITCH 1
FUNCTION: Disabled
8BIT SW 1 ARG A0:
MESSAGE
Off
8BIT SW 1 ARG A1:
MESSAGE
Off
8BIT SW 1 ARG A7:
MESSAGE
Off
8BIT SW 1 ARG B0:
MESSAGE
Off
8BIT SW 1 ARG B1:
MESSAGE
Off
8BIT SW 1 ARG B7:
MESSAGE
Off
8BIT SW 1 CONTROL:
MESSAGE
Off
N60 Network Stability and Synchrophasor Measurement System

8-BIT SWITCH 1(6)
Range: Disabled, Enabled
Range: FlexLogic™ operand
Range: FlexLogic™ operand
↓
Range: FlexLogic™ operand
Range: FlexLogic™ operand
Range: FlexLogic™ operand
↓
Range: FlexLogic™ operand
Range: FlexLogic™ operand
5 SETTINGS
5.7.14 8-BIT SWITCHES
GE Multilin