Phasor Measurement Unit - GE N60 Instruction Manual

5.4 SYSTEM SETUP
a) MAIN MENU

PATH: SETTINGS SYSTEM SETUP
 PHASOR MEASUREMENT
 UNIT
The N60 Network Stability and Synchrophasor Measurement System is provided with an optional phasor
measurement unit feature. This feature is specified as a software option at the time of ordering. The num-
ber of phasor measurement units available is also dependent on this option. Refer to the Ordering section
of chapter 2 for additional details.
The

PHASOR MEASUREMENT UNIT

5
source, ID and station name, calibration data, triggering, recording, and content for transmission on each of the supported
ports. The reporting ports menus allow specifying the content and rate of reporting on each of the supported ports.
Precise IRIG-B input is vital for correct synchrophasor measurement and reporting. A DC level shift IRIG-B receiver
must be used for the phasor measurement unit to output proper synchrophasor values.
NOTE
The PMU settings are organized in logical groups as follows.

PATH: SETTINGS SYSTEM SETUP
 PHASOR MEASUREMENT
 UNIT 1
5-82

PHASOR MEASUREMENT UNIT
 PHASOR MEASUREMENT
 UNIT 1
 PHASOR MEASUREMENT
MESSAGE
 UNIT 2
 PHASOR MEASUREMENT
MESSAGE
 UNIT 3
 PHASOR MEASUREMENT
MESSAGE
 UNIT 4
 REPORTING OVER
MESSAGE
 NETWORK
menu allows specifying basic parameters of the measurements process such as signal

PHASOR MEASUREMENT UNIT
 PMU 1 BASIC
 CONFIGURATION
 PMU 1
MESSAGE
 CALIBRATION
 PMU 1
MESSAGE
 COMMUNICATION
 PMU 1
MESSAGE
 TRIGGERING
 PMU 1
MESSAGE
 RECORDING
N60 Network Stability and Synchrophasor Measurement System
5.4.6 PHASOR MEASUREMENT UNIT
See below.
See below.
See below.
See below.
See page 5-97.

PHASOR MEASUREMENT UNIT 1(4)
See page 5-83.
See page 5-84.
See page 5-85.
See page 5-87.
See page 5-94.
5 SETTINGS
GE Multilin