Shining 3D EinScan-Pro+ User Manual page 34

Auto Scan
After simplification, the polygon numbers, size and surface detail of data will be reduced
accordingly. Check the simplify check box and set the ratio, the default is 100%.
The comparison of detail between before simplification and after simplification (at 30% simplify
proportion).
Before simplification
Fill holes
The default does not check the mark point and fill hole, check the fill hole you need set
perimeter, choose 10-100mm perimeter to fill the hole, less than the perimeter of the hole will
be filled. Mark point fill hole as an example.
After
Note：
1. If the edge of the hole is not smooth may cause the effect is not good, not
recommended to fill hole.
2. Hole-filling: choose 10-100mm perimeter to fill the hole;
After simplification
Before
33