After Scanning - Shining 3D EinScan-Pro+ User Manual

Auto Scan
windows for Manual align, as shown on the right.
Delete Current Data
If you are not satisfied with current scanning data, or
there is not enough overlapping region for registration,
click the button to delete current data and then change the
position of the scanner or the object to scan again.
When auto scan mode is scanning, you can click the
button to stop the current scan. The current data will be
deleted directly.
When import project, click the button and it will remove the
single data.
Pause
Click the button, scanning will pause; Click again to resume scanning.

1.2.3. After Scanning

Mesh
When the scan is completed, click the botton, proceed to post-processing. You will see
two modes after clicking the button: Watertight and Unwatertight. Watertight usually
slower than unwatertigt. Texture scan mode will take more time compared to Non-Texture scan
mode.
Watertight
Closed model can be printed directly. After choose this mode, you should select
the object details.
Select High for objects with fine texture, select Med or Low for objects in smooth
surface or with less detail. The time for data processing is in relation to the detail
setting. The higher the level of details is, the longer time the processing takes. It may keep for a
long time in 95%, please be patient.
Select the object details：
30