Setup And Preparation; Pre-Operation Procedures; When Using The Master Function - Mitsubishi Electric QJ71DN91 User Manual

5 SETUP AND PREPARATION

5 SETUP AND PREPARATION

5.1 Pre-operation Procedures

5.1.1 When using the master function

Perform hardware test. (Mode 9)
Set node No.
Set mode to 0, 1, or 2.
Connect DeviceNet cable to QJ71DN91.
Use GX Configurator-DN?
5
Auto configuration (See Section 7.3.1 (1).) *1
Execute auto configuration. Not needed when setting
parameters for master function manually.
Parameters for master function (See Section 7.3.1 (2).)
Set parameters for master function.
Auto communication start setting (See Section 7.3.1 (1), (2).)
Set auto communication start setting. Not needed when starting
I/O communication by I/O Communication Request (Y11).
Saving parameters to flash ROM (See Section 7.3.1 (3).)
Save parameters to flash ROM.
Refresh setting (See Section 7.4.1.)
Configure auto refresh settings. Write intelligent
function module parameters to CPU module.
Programming for control (See Section 7.4.1.)
Create sequence program for control. After writing it to
programmable controller, reset CPU module.
5 - 1
This chapter describes the procedures to be followed before starting the system that
includes the QJ71DN91.
Start
Not use
Use
Failed
Test run
OK
Operation
*1: Check that power supplies to slave nodes and network are on and the wiring is correct.
(See Section 5.4.)
(See Section 5.3.2.)
(See Section 5.3.3.)
(See Section 5.5.)
Auto configuration (See Section 7.3.1 (1).) *1
Create sequence program for executing auto
configuration. Not needed when setting parameters for
master function manually.
Parameters for master function (See Section 7.3.2 (2).)
Create sequence program for setting master function
parameters.
Auto communication start setting (See Section 7.3.2 (3).)
Create sequence program for auto communication
start setting. Not needed when starting I/O
communication by I/O Communication Request (Y11).
Saving parameters to flash ROM (See Section 7.3.2 (3).)
Create sequence program for saving parameters to
flash ROM.
Refresh setting (See Section 7.4.2.)
Create sequence program for refresh.
Programming for control (See Section 7.4.2.)
Create sequence program for control. After writing it to
programmable controller, reset CPU module.
Test run
Set Request for Saving Parameters to Flash ROM
(Y17) to on to save parameters to flash ROM.
MELSEC-Q
Failed
OK
5 - 1