Facing Template Removal - Quadra-Fire QFP38-LP Owner's Manual

Doors - Outside Surface Fit
Sheetrock/wall fi nishing material will have been installed
and the joints fi lled.
• Remove facing templates, retain screws for door
installation.
• Non-combustible facing material less than one inch thick
may be brought to the edge of the fi replace opening.
• Doors will be mounted over facing material.
• Door frame is slotted to allow the door to be mounted
up to one inch from the surface of the fi replace.
Figure 14.3 Door Frame Flush to Bottom Edge of Fireplace
Doors - Recessed Fit
Sheetrock/wall fi nishing material will have been installed
and the joints fi lled.
• Facing material must be butted to the fl anges of the
facing templates.
• Remove templates - retain screws for door installation.
B. Facing Template Removal
There is a metal template on each side and across the
top of the door opening. See Figure 14.4.
•
•
Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09
Side Templates
- Remove the screws from the sides of the door
opening and set aside.
- Remove and discard the template pieces.
Top Template
- Loosen the screws across the top of the opening.
- Slide the top template out and discard.
- Tighten the screws.
Template
Figure 14.4 Facing Template
Pieces
55