Quadra-Fire QV26E Owner's Manual
Quadra-Fire QV26E Owner's Manual

Quadra-Fire QV26E Owner's Manual

Electric fireplace/insert installation and operation

Advertisement

Quick Links

Models:
QV26E
Electric Fireplace/Insert
Important operating
a n d m a i n t e n a n c e
instructions included.
WARNING
If the information in these instruc-
tions is not followed exactly, a
fire may result causing property
damage, personal injury, or death.
• Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of
this or any other appliance.
• Comply with all minimum clearances to
combustibles as specified. Failure to
comply may cause house fire.
CAUTION
DO NOT DISCARD THIS MANUAL
Read, understand
and follow these
instructions for safe
i n s t a l l a t i o n a n d
operation.
Quadra-Fire • QV26E • 4038-827 Rev E • 02/05
Owner's Manual
Installation and Operation
Leave this manual with
party responsible for
use and operation.
WARNING
HOT! DO NOT TOUCH.
SEVERE BURNS MAY RESULT.
CLOTHING IGNITION MAY RESULT.
Glass and other surfaces are hot
during operation and cool down.
Keep children away.
CAREFULLY SUPERVISE children in same room
as heater.
Alert children and adults to hazards of high
temperatures.
Keep clothing, furniture, draperies and other
combustibles away.
1

Advertisement

Table of Contents
loading

Summary of Contents for Quadra-Fire QV26E

  • Page 1 • Comply with all minimum clearances to • Alert children and adults to hazards of high combustibles as specified. Failure to temperatures. comply may cause house fire. • Keep clothing, furniture, draperies and other combustibles away. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 2 Hearth & Home Technologies Inc. 1915 W. Saunders Street Mt. Pleasant, IA 52641 UL 2021 FIXED AND LOCATION DEDICATED ELECTRIC ROOM HEATER VOLTS: 120V MODEL XXXX DATE WATTS: 1500W SERIAL XXXXXXX FREQUENCY:60Hz Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 3: Table Of Contents

    C. Mantel ........14 Note: An arrow () found in the text signifies change in content. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 4: Listing And Code Approvals

    S AV E T H E S E I N S T R U C T I O N S F O R F U T U R E service facility for examination, electrical or mechanical REFERENCE. adjustment, or repair. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 5: Getting Started

    Actual installation may vary slightly due to individual design preferences. The illustrations and diagrams used throughout these installation instructions are not drawn to scale. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 6: Selecting Heater Location

    Immediately call a qualified service technician to inspect heater and to replace any part of the control system which has been under water. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 7 9-3/4 in. (248 mm) 1/2 in. min. (13 mm) 9-3/4 in. 1 in. min. (248 mm) (26 mm) Model # 26-1/2 18-1/2 26-1/8 QV26E Figure 3.1 Heater Locations Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 8: Frame The Heater

    24 in. (610 mm), 28 in. (711 mm) and 32 in. (813 mm) high. 22-7/8 in. (581 mm) (header height) 26-1/2 in. (673 mm) 9-3/4 in. (248 mm) Figure 3.2 Framing the Heater Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 9: Installation

    flanges on both sides of the heater and nail to the framing. • To finish out the heater, follow the instructions found in Section 6. • To complete heater installation, see Section 5. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 10: As An Insert

    If necessary, use the leveling bolts included in the manual bag. Screw the bolts into the nuts installed in the bottom of the insert (see replacement parts diagram). Turn bolts in until the insert is level. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 11: Wiring

    If installing inside a pre-existing fireplace and if permitted by local codes, an electrician may install an outlet box inside the existing fireplace. Place the outlet in the lower back of the firebox. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 12 FLAME MOTOR THERMAL HIGH BLUE LIMIT RED 2 PIN 1300 WATT HEATER 16 Ga YELLOW 4 PIN 16 Ga AMP AC BLOWER MOTOR ORANGE 3 PIN Figure 4.1 110V/120V Wiring Diagram Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 13: Accessories

    Do NOT operate this heater without the front face installed. Installation of other optional accessories may be done at this time. The heater is now ready for operation. See Section 7. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 14: Finishing

    Note: Finishing materials are normally installed behind the nailing flanges or up to the sides of the nailing flanges. Allow room for the front to be added and the heater to be anchored. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 15: Operating Instructions

    Do NOT store flammable materials close to heater. • Keep all such liquids well away from the heater while it is in use. Figure 7.1 General Operating Parts Combustible materials may ignite. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 16: Troubleshooting

    2. Replace the batteries. Odor. The heater may emit a slight, harmless odor when first used. This is a normal condition caused by initial heating of the internal parts and will not occur again. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 17: Maintenance And Service

    Place the new bulb in the socket. See Figure 9.2. Follow directions on the light bulb package for handling requirements. Bulbs • Reinstall the hearth assembly. Figure 9.2 - Replacing the Bulbs Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 18: Maintenance Task List

    2. Confirm there is no damage to glass or glass frame. Replace as necessary. 3. Clean glass using a non-abrasive cleaner such as Brasso©. Circulation Compartment 1. Remove any foreign objects. 2. Verify unobstructed air circulation. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 19: Reference Materials

    1 in. (26 mm) 1 in. (26 mm) 22-7/8 in. 16 in. (581 mm) (407 mm) 22-5/8 in. (575 mm) 26 in. (661 mm) 4-1/4 in. (108 mm) 27-5/8 in. (702 mm) Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 20: Optional Components

    PBT = Polished Brass Trim PBT26EA PBT26ER SST26EA SST26ER SST = Stainless Steel Trim Cabinets Several styles of cabinets are available for use with these heaters. See your dealer/distributor for styles and sizes. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 21 28 in. 24 in. DF-26ERA-BK4028 Remington Avenue 40 in. 28 in. DF-26ESP-BK4028 Sun Prairie 40 in. 28 in. DF-26ERA-BK4432 Remington Avenue 44 in. 32 in. DF-26ESP-BK4432 Sun Prairie 44 in. 32 in. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 22: Service Parts

    C. Service Parts QV26E Service Parts Beginning Manufacturing Date: 04/04 Exploded Parts Diagram Ending Manufacturing Date: Active QV26E Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 23 Control Switch Wire assy 4038-814 Thermistor 4038-849 Strain Relief Bushing (Power Cord) 4030-873 Strain Relief Bushing (Switch Wires) 25756 Gasket 9018 2 ft Slide Pot Rubber Boot 4038-811 Reflective Flame Decal post 32/04 4021-190 Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 24: Limited Warranty

    ADDITIONAL INFORMATION. If you would like information on current Quadra-Fire products or want to locate a dealer in your area, call 1-800-926-4356. ©2003 Quadra-Fire® is a Registered Trademark of Hearth & Home Technologies Inc. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...
  • Page 25: Contact Information

    5947112, 5996575, 6006743, 6019099, 6048195, 6053165, 6145502, 6170481, 6237588, 6296474, 6374822, 6413079, 6439226, 6484712, 6543698, 6550687, 6601579, 6672860, 6688302B2, 6715724B2, 6729551, 6736133, 6748940, 6748942, D320652, D445174, D462436; (Canada) 1297749, 2195264, 2225408; or other U.S. and foreign patents pending. Quadra-Fire • QV26E • 4038-827 Rev E • 02/05...

Table of Contents