Table of Contents
Advertisement
13
13
Electrical Information
A. Wiring Requirements
NOTICE:
This appliance must be electrically wired
and grounded in accordance with local codes or, in the
absence of local codes, with National Electric Code
ANSI/NFPA 70-latest edition or the Canadian Electric
Code CSA C22.1.
•
Wire the appliance junction box to 110-120 VAC. This is
required for use of optional accessories (standing pilot
ignition) or proper operation of the appliance (Intellifi re
ignition).
•
A 110-120 VAC circuit for this product must be protected
with ground-fault circuit-interrupter protection, in
compliance with the applicable electrical codes, when
it is installed in locations such as in bathrooms or near
sinks.
•
Low voltage and 110 VAC voltage cannot be shared
within the same wall box.
WARNING! Risk of Shock or Explosion!
110V to the valve or to the appliance wall switch. Incorrect
wiring will damage controls.
B. Technical Data
•
•
C. Intellifi re Ignition System Wiring
•
WARNING! Risk of Shock or Explosion! DO NOT wire
IPI controlled appliance junction box to a switched circuit.
DO NOT wire
Incorrect wiring will override IPI safety lockout.
•
WARNING! Risk of Shock!
disconnection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock!
type 105° C rated wire. Wire must have high temperature
insulation.
Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09
Remote Control
-
Supply voltage: 4.5 V (three 1.5 V AAA batteries)
-
Ambient temperature ratings: 0 to 60° C (32 to
140° F).
-
Radio frequency: 315 MHz
Receiver
-
Supply votage: 6.0 V (four 1.5 V AA batteries)
-
Ambient temperature ratings: 0 to 60° C (32 to
140° F)
-
Radio frequency: 315 MHz
Wire the appliance junction box to 110 VAC for proper
operation of the appliance.
Refer to Figure 13.1 System Wiring Diagram and 13.2
Wiring Diagram.
Label all wires prior to
Replace damaged wire with
51
Advertisement
Table of Contents
