Setting the lawnmower operation
Manual mode
With this function, you can configure the lawnmower to mow without the work
timer function.
NOTE:
- If you want to operate the lawnmower with [Manual mode], see "Operating the lawnmower with the
Manual mode" (M page 72)
Mowing pattern
You can select from 3 mowing patterns below:
[Random]
With the [Random] setting, when the
lawnmower detects the boundary wire,
it turns at a wide angle. This is the most
effective for mowing a large open area of
grass. For normal operation, use this setting.
Spiral cutting:
With this function, the lawnmower can be focused on mowing the area where the lawn is not completely
mown, or the growth speed of the lawn is fast.
Edge cutting:
With this function, you can mow the unmown area along the boundary wire.
38
[Mixed]
With the [Mixed] setting, the lawnmower alternates
between the [Random] mowing pattern and the
[Directional] mowing pattern at regular intervals.
[Directional]
With the [Directional] setting, when
the lawnmower detects the boundary
wire, it turns at a narrow angle. This is
used for mowing narrow areas.
The lawnmower detects the
dense area and mow there
spirally.
If the edge cutting setting is
enabled, the lawnmower goes
around your garden along
the boundary wire to mow the
edge before starting the usual
mowing.