Page 1
Service & Support Service & Support Service & Support HRM310K1 HRM310K1 HRM310/520 HRM310/520 HRM520K1 HRM520K1 xxxx.xxxx.xx xxxx.xxxx.xx Honda Motor Co., Ltd. 2017 Honda Motor Co., Ltd. 2017 xxxx.xxxx.xx xxxx.xxxx.xx Service & Support Service & Support https://www.hondappsv.com/HME/ https://www.hondappsv.com/HME/ https://www.hondappsv.com/HME/ https://www.hondappsv.com/HME/ https://www.hondappsv.com/HME/ Please refer to "5.Mii-monitor Preparation"...
Page 3
How to switch Miimo ON and enter PIN QUICK REFERENCE Long Press “ON-OFF” ( ) button Either: Connect to Miimo by Bluetooth in Mii-monitor and enter PIN Home Or use “Home” ( ) and “Mode/Activate” ( ) button to enter pin as below Mode/Activate (long press) •...
INSTALLATION INTRODUCTION Thank you for buying the Honda Miimo HRM1000. This product has a different Most Miimos are physically installed and set up by our network of trained, authorised user interface compared to the other models in our Miimo range. The owner’s Honda dealers.
Page 5
If you are within 5m of Miimo and your Bluetooth is switched ON (in case Honda Miimo frame number, which can be found on the inside of the display of Apple and Android devices) and paired (only for Android devices) cover of Miimo.
If the Bluetooth icon does not turn blue then make sure “Location” setting is Most Miimos are set up by our network of trained Honda dealers. But if you want switched ON for the application. This can be done after first log-in to Mii-monitor to set Miimo up yourself or if you have just carried out a factory reset, when you (fig.1).
LAYOUT OF DISPLAY SCREEN HOW TO CONTROL MIIMO USING THE DISPLAY There is a visual guide to using HRM1000 on a sticker inside the display cover. (Mode/Activate) button Indicator Press to confirm command. The mode and error Please see below for more details. Press and hold switch status are indicated by between the Auto mode and...
If you are still unable to clear the error then please contact your Honda Authorised Dealer If the LED is OFF and Miimo has stopped operating, please follow the procedure in the next section.
STOP THE THEFT ALARM The theft alarm sounds when Miimo has been lifted for more than 9 seconds. To stop the theft alarm from sounding simply press the “Mode/Activate” ) button. Normally, when the theft alarm stops, the LED should become blue green yellow...