How To Use The Standard Operation Panel - JUKI SC-510 Engineer's Manual

(2) How to use the standard operation panel

5
1
/ switch
2
/ switch
3
switch
4
switch
5 PATTERN SELECTION display :
6 REVERSE STITCHING
AT START display
7 REVERSE STITCHING
AT END display
8 NUMBER OF STITCHES display :
9 MATERIAL EDGE SENSOR
display
!0 ONE-SHOT AUTOMATIC
STITCHING display
!1 AUTOMATIC
THREAD TRIMMING display
!2 THREAD TRIMMING
PROHIBITION display
7
6
2
1
: Used for determining the contents of setting.
When this switch is pressed, flashing stops and the contents of setting
are determined.
: Used for changing the contents of setting.
When this switch is pressed, changeable positions flash on and off.
By pressing the switch, flashing position shifts in the right direction.
: Used for changing the contents of the selected display (flashing
section).When this switch is pressed, the contents of the display
increase.
: Used for changing the contents of the selected display (flashing
section).
When this switch is pressed, the contents of the display decrease.
The selected pattern is displayed.
: Rendered effective when reverse stitching pattern is selected.
" " Without reverse stitching display / " " Reverse stitching display/
" " Double reverse stitching display
: Rendered effective when reverse stitching pattern is selected.
" " Without reverse stitching display / " " Reverse stitching display/
" " Double reverse stitching display
Number of stitches of reverse stitching or overlapped stitching is
displayed.
: Lights up when the material edge sensor setting is selected.
Function setting No. 2
: Lights up when the one-shot automatic stitching is selected.
Function setting No. 76
: Lights up when the automatic thread trimming by depressing the
front part of the pedal is selected.
Function setting No. 3
: Lights up when the thread trimming prohibition is selected.
Function setting No. 9
− 8 −
9
8
!1
4
3
!0
!2