JUKI SC-510 Engineer's Manual page 26

8 Selection of the optional input/output function (Function setting No. 12)
1 2 O P
9 0 0 _ E
i n
o u
9 0 1 *
Optional input
1 to 8 are
displayed.
9 0 8
9 1 1 *
Optional output
1 to 8 are
displayed.
9 1 8
(Caution) Note that the voltage used in output function should not exceed the voltage set with W1
and W2.
* Example) Setting the thread trimming function to the optional input port 1
1 2 O P
9 0 0 i n
9 0 1 n
T
9 0 1
Lighting alternately
L
L
9 0 1
H
9 0 2 n
9 0 0
E
* For the other optional function, it is possible to program simple input/output sequence control.
Operation keys array
1. Select function No. 12 with the operating procedures described in the item
T _
of how to change over the function setting mode (1) to (4).
Select the items of "End", "in" and "ouT" with keys 3 and 4.
n d
_ _
T _
[When "in" is selected]
* *
The port Nos. are displayed in the left 3 digits. Designate the input port with
key 1 or 2. Designate the function of input port with key 3 or 4.
The function code and the abbreviation are alternately displayed in the 4-digit
LED.(For the relation between signal input No. and connector pin array, refer
to the separate list.)
[When "ouT" is selected]
* *
The port Nos. are displayed in the left 3 digits. Designate the output port with
key 1 or 2. Designate the function of output port with key 3 or 4.
The function code and the abbreviation are alternately displayed in the 4-digit
LED. (For the relation between signal input No. and connector pin array, refer
to the separate list.)
1. Select function No. 12 with the operating procedures described in the item
T _
of how to change over the function setting mode (1) to (4).
2. Select the item of "in" with keys 3 and 4.
_ _
3. Select the port of 901 with key 2.
o P
4. Select the thread trimming function, "TSW" with keys 3 and 4.
S W
4
5. Determine the thread trimming function, "TSW" with key 2.
6. Set ACTIVE of the signal with keys 3 and 4.
4
Set the display to "L" when the signal is "Low" and performing thread
trimming, and set the display to "H" when the signal is "High" and performing
4
thread trimming.
7. Determine the aforementioned function with key 2.
o P
8. Finish the optional input with key 2.
i n
9. Select the item of "End" with keys 3 and 4 to return to the function setting
n d
mode.
1 2
21
− −
4 3