JUKI SC-510 Engineer's Manual page 29

9 Sewing counting function (Function setting No. 14)
The function counts up every time thread trimming is completed and counts the number of completion of the
sewing process.
This can be realized together with the CP-160 control panel. Refer to the explanation of the control panel.
1 4
(Caution) Setting will be invalid when the material end sensor is not attached, or CP-160 control
panel is connected.
!0 Function of reverse feed stitching switch (Function setting No. 15)
Function of reverse feed stitching switch is selected.
1 5
!1 Alternate vertical amount input function (Function setting No. 18)
Function of alternate vertical dial of LU series is selected.
1 8
!2 Reversing brake start angle (Function setting No. 19)
Brake start angle of function of reverse revolution to lift needle after thread trimming can be set. Set value
sets the angle from position of UP detection missed.
1 9 3
As to angle : Angle here means that the angle is that of direction of the normal rotation from missing of UP
detection when the sewing machine rotates in the normal direction.
!3 Alternate vertical amount output delay time (Function setting No. 20)
Delay time from pressing alternate vertical presser switch of LU series to outputting of alternate vertical
output signal is set.
2 0
!4 Neutral automatic presser lifting function (with AK device only) (Function setting No. 21)
This function can automatically lift the presser foot when the pedal is in the neutral position.
Automatic lifting time of the pedal depends on the automatic lifting time after thread trimming and when the
presser foot is automatically lowered, it is automatically lifted at the second neutral position after it has come
off the neutral position once.
2 1
0 : off Sewing counting function is inoperative.
1
(Indication on the CP-160 contorl panel will go out as well.)
1 : on Sewing counting function is operative.
0 : Reverse feed stitching function of normal operation used with lockstitch
0
machine, and the like
1 : Level input wrapper control and presser synchronizing control
2 : Level input wrapper control
3 : Alternate input wrapper control
0 : Function not selected
0
1 : Analog input (Analog input of DL dial from optional input connector CN51 4-
2 pin is possible. It corresponds with DL dial of LU-22* series.)
2 : Digital input (DL dial input function of digital input from optional input connector
CN51 4-1 and 4-2 pins is possible. It corresponds with DLdial of LU-15*
series.
0 : Invalid (Brake works from position of UP detection missed.)
5 9
Setting range 1 to 359 [degree]
1 to 359 : Brake works after rotating up to the set angle.
Setting range : 0 to 500 [mS]
1 0
0 : off Function of neutral automatic presser lifting is not operative.
0
1 : on Selection of function of neutral automatic presser lifting
24
− −