JUKI SC-510 Engineer's Manual page 35

#5 Selection of thread trimmer and additional device (Function setting No.65)
Thread trimming control corresponding to the machine head is selected. When additional device is
mounted, device function is set.
6 5 F U n
Setting item is selected by operating 3 and 4.
LED 3-digit display
F U n
Setting item is determined by operating 1 and 2.
F U n T r
TrM : This is setting when using thread trimmer mechanism built in the machine head. Models for which this
setting is possible are as described below.
LED 3-digit display
T r. 0
(Caution) Contents of thread trimming function can be automatically set as well at the time of the
function setting. Therefore, it is not necessary to set the function normally.
LED 4-digit display
E n d
T r M
U T 1
U T 2
M
LED 4-digit display
n o
L 1 5
L U 2
L 1 5
d 6 3
2
1
End of setting (Setting returns to the
normal function setting.)
Selection of thread trimmer function
Setting of additional device 1 function
Setting of additional device 2 function
Applicable model
p Setting invalid
1 Machine head of LU-151** series
2 Machine head of LU-22** series
2 Machine head of LU-152* series
9 DLN-6390
30
− −
4
3
Remarks