JUKI SC-510 Engineer's Manual page 38

#6 Simplified program setting (Function setting No. 66)
Valid/invalid of motion of simplified program, and input, change, etc, of program are set.
6 6 P r
#7 Auto hemmer control changeover (Function setting No. 67)
Auto hemmer control used with MF is selected.
6 7
Contents of setting list
At the time of turning
• Air blow : OFF
ON the power • Hemmer guide : ON
• Presser lifter : ON (lifting)
Depressing the back • Presser lifter comes down by
part of pedal depressing pedal
(When it is shallowly • Air blow : ON
depressed)
• Hemmer guide : OFF
Aforementioned motions are
alternately repeated
by shallowly depressing the back
part of pedal.
#8 Prohibition of start with material end sensor of auto hemmer control (Function setting No. 68)
Setting whether starting sewing machine or not with material end sensor of auto hemmer control used with
MF is performed.
6 8
#9 Selection of speed control method after detection of material end sensor of auto hemmer control
(Function setting No. 69)
Setting whether by manual or automatic the speed control after detection of material end sensor of auto
hemmer control used with MF is possible.
6 9
$0 Number of stitches of invalid material end sensor of auto hemmer control (Function setting No. 70)
Setting of number of stitches which makes invalid detection of material end sensor of auto hemmer control
used with MF can be set.
7 0
$1 Clutch motor function (Function setting No. 72)
This function makes valid the function which performs same motion as clutch motor.
7 2
When this function is set to valid, UP/DOWN stop function by synchronizer or the like attached after set-up
of the machine does not work, and only rotation stop motion by depressing pedal works.
For the details, refer to "(2) of 9. How to use the simplified program function".
o _
0 : Control 1
0
1 : Control 2
Control 1
0 : Invalid (Sewing machine is started regardless of detection of material end
0
sensor.)
1 : Valid (Sewing machine is not started in case of detection of material end
sensor.)
0 : Pedal depressing amount
0
1 : Setting speed (Motion with setting speed of function setting No. 38)
0 : Invalid
0
Setting range 1 to 500 [Unit : 0.5 stitch]
0 : Invalid
0
1 : Valid
Control 2
• Air blow : OFF
• Hemmer guide : OFF
• Presser lifter : ON (lifting)
• Air blow : ON
• Hemmer guide : ON
• Presser lifter : ON (lifting)
• When pedal is returned to neutral position,
air blow and presser lifter are OFF (lowering).
• Hemmer guide is not OFF until overlapped
section sensor detects after making hemmer
guide output once ON.
33
− −
Remarks